Kulkoni, Inc. 1-800-231-2357

A Q U A L L I N E A Q U A L I N E • For the socketing: Make sure the conical house of the Connector Fitting is clean and free of dust, paint, or grease. The end of the wires stays below the threaded holes of the safety screws but should be as high as possible up in the cone of the Connector Fitting. • As soon as the resin is cured, the complete unit can be reassembled: Insert the Connector Fitting in the Adjustable Open Spelter Socket. Screw the safety screws in place. Adjust the length of the assembled Adjustable Open Spelter Socket. Secure the assembly with the hexagon bolt. • These are identical to the Adjustable Open Spelter Sockets, with the only distinction that each Adjustable Turnbuckle Socket contains two Connector Fittings, which means that all actions involving the Connector Fitting should be duplicated. • • Each Connector Fitting is equipped with an anti-rotation device to avoid spinning in the socket. • During socketing, make sure that the resin fully reaches the wire inlet at the bottom of the socket. • After socketing, a thread-locking adhesive should be used to secure the Connector Cap to the Connector Fitting. • The eye on the Connector Cap is designed to easily reeve the Connector Fitting with the wire rope into the block or crane. The eye should never be used as a lifting device. • Our AQUALLINE Open DIN Sockets meet the performance requirements of the DIN 83313 norm and exceed the required MBL. For the exact MBL values we refer to our product datasheet. • These AQUALLINE wire rope terminations meet the performance requirements of the JIS F 3432- datasheet. A Q U A L L I N E P R O D U C T S Official Distributor | KULKONI INC. 19